hlw49's latest activity

There should have been an oring inside the plastic ring.

Nova 2 makes a chip to replace the points and condensor on small engines. They work on most all point type ignitions. Install it and if...

I just love this thread! All of the internet scientists 🤣🤣🤣🤣🤣 I'm not a qualified internet scientist but i did stay a a holiday inn...

Have a Tanaka TBC340 trimmer I bought in 2004 have always used non-ethanol fuel in it and have never done a carb job on it. Go out prime...

TDC on the compression stroke is the only place both valves are fully closed at the same time. Briggs says piston 1/4 inch past TDC.

The fuel bowl should be full of fuel at all times except when ran dry. The solenoid doesn't stop fuel from flowing into the carb, and...

Sorry I did not get back to you sooner. I work for a Dixie Chopper dealer and have for the last 16 years. Here is the way I do it and...

Some of the Intek singles have a fuel pump. It is located on the left rear corner of the engine and powered by a pulse line coming off...

The only thing that stop magentism is distance.

No not the problem clean carb and fresh fuel.

Welcome to the forum lots of good guys here willing to help. Hope we can help when needed.

That's a thought I'll try it.

Briggs 104M02-0005-F1 engine on a Snapper walk behind 12AVB2A2707 SER 1K195K31260. Customer brought it in and said it sounds like it is...

Welcome to the site

Cylinder leak down test is probably the best test you can run to determin the problem.