Recent content by gdrepairs69

Toro Wheelhorse 264-6 Model #72042 S# 490000 etc. When turninng key to start I get clicking on the 2 black modules mounted on the plate above the battery that coves engine side of the dash, back of the control panel. What are those? Fuese good. Battery is good. Brake pedal pressed. When testing...

Got a craftsman here 2004 with SV590 19 Hp Kohler. Its getting spark, by-passed any fuel issues by using start fluid directly into the carburetor mount, it will sputter a little then thats all. Should make it fire to 2-3k rpm? Basic compression test with one of those that you screw in the hose...

I accidentally took apart this key switch 925-04227 and needed to test it but not sure how to aline it back together. Any thoughts and help would be great..... :confused2:

Need advise! Could I not just remove the axle housing to repair the leaking of oil here around the axle (oil seal & bearing) as it comes out of the housing. Based on the diagram I don't see why that one would need to remove the transmission from under the tractor. Just Unbolting the axle housing...

I have a older GX110 Honda push mower. I need to know like if you hook up a multimeter to the spark plug cap and then pull over the engine, what is the minimum voltage to be acceptable?

Battery is good new solenoid clicks to engage but only getting 3 to 6 volt at the starter?:confused2:

Here I have a Briggs 128T02-0118-B1 on a John Deere a guy brougth me a month ago with a starting problem, the mower is only 2 years old. I got it started by using some starter fluid and would run on it and start so I basically removed the carb and put in a needle and set and cleaned up the carb...

Murray model #461007X92A Briggs 21 hp opposed twin 461707-0116-E1 I have (spark )and good compression. Seem to have good fuel supply but just spins over without even a sputter? Could there still be a electrical problem fuse is ok and set switch ok. How to either isolate the problem to the...

Please HELP MTD 1993 Briggs engine how to remove old shaft pin on starter recoil? ]Briggs engine how to, what do you use to remove old shaft pin in the center on starter recoil? See picture attachment.

What would cause gas to leak from this hole in the carburetor until the tank is empty?