Recent content by Freddie21

Check this out:

To align the steering straight. Remove the pinion gear from the bottom of the steering shaft, mark the ceter tooth of the large gear , place the steering wheel straight and while keeping this all in position put the pinion gear back on.

Couple things, You may have a bad battery, solenoid, starter or locked engine. You indicated 127mv at the starter lead of the solenoid when the key is turned. This should be 12v as the solenoid passes the 12 from the battery connection to the starter. If the solenoid is clicking and the...

Every pulley should turn very easily without and noise. They will heat up due to friction and tighten up. All arms and brackets should rotate freely. Use penitrating oil and force to free them, then lube with a good oil. If the PTO clutch clicks, then I would think it's working, but there is...

Clean the flywheel and mag\coil with emery paper and size gap to 0.010" (business card). Load from deck could be pulleys\spindle bearings. Check main drive belt routing and idlers.