Freddie21's latest activity

If you would give the engine model number, we could verify what starter pn, but since you won't, try this info. Just the gear is...

Cut the plugs off leaving some wire to work with, strip, twist, solder and heat shrink. Don't just barrel crimp and call it done. Not...

I agree with Rivits's assumption. The black pulley looks tilted towards the fron of the deck. It also looks low to the spindle pulley...

As BGS states, if this is a Briggs engine, coming to the engine connector are two charging wires (may be in smaller connector). One...

I shy away from all governor adjustments unless 100% needed.

What I see is that the throttle cable seems to be too long towards the carb. To adjust the cable, disconnect it from the holding clamp...

I buy engines off MP is also an option. I find ones that have been removed from machines with bad transmissions. I have to hear it run...

I just went through all this nonsense with the identical engine. Thought it was knocking. After disassembly and checking all the...

Follow the path of the belt around the complete deck. Look for signs of it rubbing on the deck itself or other components, such as...

Stay away from 8Ten belts, short life.

Here's a link: https://www.amazon.com/HD-Switch-Adjustable-YTH24V42LS-YTH24V54XLS/dp/B097V3QFGC

Model number is 13AQA9TTA10 and ILENGINE is correct on the pn. 954-0522A

Per your date code, use RTV on the valve cover rather than a gasket.

Carb solenoid is not yet the issue. I read it as you have fuel to the pump, but it doesn't get pumped out. I have used a small...

Unless you're going tto trash that motor, find out why the rods bent. Examine the valves and rockers. Are they way out of adjustment...