Forest#2's latest activity

I do not see where you have done this. You DO NOT need a tachometer for this test. To eliminate the governor hunting instead of...

Just a hint: I would suspect the 20 amp fuse holder and the #3 terminal of the engine harness connector FIRST and next the connection at...

The varnish wasn't 1/8" inch thick. It was 1/8" up the side from the bottom. I thought about cutting out the baffle. Was looking at...

The 26-27v DC you are reading should be close to ZERO. It is indicating that you have a bad connection between the center terminal of...

Found my fiber optic proctiscope that I thought my son had pilfered. Looked in the tank and it was a lot cleaner than I thought...

try this link for some info...

Was that made in 1864??

If it quits at exactly the 20min run time, try resetting your timer when it gets to 15 min and see if it runs longer. That being a...

Just some thoughts to kick around while you are swishing your cold beer. Why not get rid of the plastic insert if it's just used as a...

Regular Acetone can do a lot damage to both other metal items and you as it gases off when exposed to the moisture in the air. I have...

Just to help you. I have shortened the long fuel pickup to and put fuel line from a weed eater and a weed eater fuel filter on then end...

Some hints about the Briggs dual tube pulsa jet carbs AND also if you keep the gas tank over 1/2 full the cup at the top for the short...

Look on FB at pressure washers with the Honda engines. I see one every once in awhile for FREE that has bad pump. Also I've cleaned...

I made one (several) to break down the bead for the 4, 6 and 8 inch dia front rims, especially the deep dish 8 inch rims. Some of the...

Read post #43 The key is only for timing. Make sure the crank taper and the flywheel taper are degreased. Torque to specs and go mow...