Forest#2's latest activity
-
FForest#2 replied to the thread Big trouble pulling GCV190 flywheel.Stay patient. I've seen some rough ones. I've left the puller on some overnight and go back next day and they were popped. You really...
-
FI recommend you replace the drive belt along with the stationary and idler pullies. The single speed F/R transmission in these old...
-
FForest#2 replied to the thread Adding Transmission Fluid?.All good info above. What I would do since it's a new you you free machine. and you want to work on it yourself Download a owners...
-
FForest#2 reacted to ILENGINE's post in the thread B&S model 31H7770202E1 18 HP (craftsman LT1000) with
Like.
Ignition would be my first guess, but will need to confirm loss of spark after engine dies with a open gap spark tester, not a blink... -
FForest#2 replied to the thread Craftman 5000 Watt Generator hard Starting when Hot.You say it has electronic ign and you replaced the module with a generic??? If so what specs did you set the air gap? Are you sending...
-
FForest#2 replied to the thread Craftman 5000 Watt Generator hard Starting when Hot.Couple thing you might try. First remove all loads on the gen when first starting. (and before killing the gen) Start it up cold and...
-
FA piece of painter's tape works fairly well. Put it on the tip while working the ring off with a pair of pocket screwdrivers. If...
-
FForest#2 replied to the thread Craftman 5000 Watt Generator hard Starting when Hot.Also replace the spark plug and gap it per specs. (and fresh fuel) You can download a free Tecumseh L-head manual on-line also. I've...
-
FForest#2 reacted to Auto Doc's's post in the thread Craftman 5000 Watt Generator hard Starting when Hot with Like.
If it has a low oil switch at the bottom, on the side of the block, unplug it and see if it will start when hot. These switches were...
-
FForest#2 replied to the thread 19.5hp oppy starter gear.I also call them Briggs starter c clips JESUS CLIPS. When I pry it off carefully and it goes flying high and me listening for where it...
-
FI worked office for 16 yrs and cam across a lot clips and rings. I have come across Speared End snap rings when I was tearing the 4L60E...
-
FForest#2 replied to the thread Craftman 5000 Watt Generator hard Starting when Hot.Does it have the electric starter also?? Them 10 HP Tecumsehs are not user friendly to rope crank is why I ask.
-
FForest#2 replied to the thread LT1000 Motor swap, hydrostatic does not work.You got lucky in a way, maybe. Keep a heads up around the hydro drive pulley. If the belt comes off in that area it will sometimes ruin...
-
FForest#2 replied to the thread LT1000 Motor swap, hydrostatic does not work.No Hydro's have a Neutral lever usually on the rear of the machine that allows them to be pushed. If it's set for push it will not...
-
FForest#2 replied to the thread 15 amp fuse blows.might think about getting some fuse holders and fuse each individual circuit, for example place a 10 amp fuse in the PTO clutch circuit...