Forest#2's latest activity

this is termed waste spark ignition. normally when a plug wire is purposely pulled the Onan waste spark ignition engine will not run on...

You were typing at same time as me in your post 20 For one: (in the video) as to what Rivets noticed also the belt is riding too high...

Starter solenoid and ignition switch is not likely to be the issue. You say the PTO clutch is unplugged and the PTO FUSE blows when...

this may damage the coil transistors since the High Voltage has to dump somewhere. Correct not a good thing to pull a plug wire on some...

I prefer to ground the tip of the spark plug by sliding back the insulator rather than pull the wire but if I need to pull I use I use...

You have a short on this circuit. Find out why and where on said circuit. Wires rubbing, mice chewing....... Call JD and ask for a...

Go with the genuine B&S, forget the cheap knockoff ones.

That is just a simple flat gasket with 3 holes for the screws. Easy made if damaged. I was like you at first, reluctant to go there...

Be sure you buy the real deal Briggs red. Costs more but worth it. I tried the clones, every one of them eventually started leaking at...

Quite often with the dual throat Nikki's I can get a good run leaving the carb mounted to the engine and remove enough stuff that I can...

My 407777 was doing the same symptoms, took the Nikki off and cleaned it, still acted up,, (lean backfire) I thought. Took the carb back...

Post up a link to your new post here also and we will get a heads up about such. Also maybe a video of the you are hearing. Back side...

You might get more responses if you start a new thread about your latest NEW issue instead of using the brake adjust rod playpost. If...

Have you had the deck off of the machine and thourghly/closely inspected the spindles bearings,idler pulleys, my doing a manual...

I do the same. A guy that swapped in new starters for customers gave me a big pile of starters sometime back and I've reconditioned...