Forest#2's latest activity

Not a bad design, just needs a bit more patience and understanding on how carbs work. They get a bad rap because people don’t have the...

Does the engine crank over? (or everything just seem dead)

Unhook the throttle cable and move it by hand to see if it will pull it down to idle.

With the engine not running there should be spring force trying to pull the throttle open. Yours according to the service manual has a...

A hint that yours will not idle with the engine running is you say the carb throttle shaft still feels strong spring pressure even with...

With the engine not running. I looked a couple of my opposed twins full open throttle and full closed throttle. full open throttle on...

Have you looked at the Briggs and Stratton L-Head OPPOSED TWIN service manual 271172? You can find one on-line to review the Governor...

The engine speed is controlled by a balancing act between the governor and the governor spring. When the engine is running the governor...

The compression release is on the intake valve. It dumps some compression when the piston is just before TDC if the intake valve lash is...

Auto Doc's is right on about the center spacer so the tapered bearings will not have too much pre-load when all it tight. (the shaft...

Hi BrentW, Does the center spindle shaft have a spacer pipe to make sure the tapered roller bearings are not bottomed out in the races...

LMT's are NLA. The Briggs part number will lead you to believe it's a Walbro but it's will be a Nikki or Ruxing. If you want a LMT you...

Step back and look before you break it. Most likely another fastener. If you beat on it or use knives with force you will find out why...

there should be a total of 7 bolts/studs holding the sump on. Check down those deep hole above and below the crankshaft. I think you...

I've had to SAVE a post in word BEFORE posting a reply and come back in day or two and try to post reply later. Not a good thing to type...