Recent content by fayjim2

So what should I check out. The belt has some wear but it works just fine in the higher settings . I guess I need to know why the deck doesn,t raise straight up rather than moving up and to the rear?

Why does the pto for the blades wind up faster when the deck is higher ? Belt and pto linkage are ok. The deck height system seems to me to be the culprit. Rather than lift system lifting the deck straight up keeping belt tension equal regardless of position. When raising it moves the deck to...

I started this thread for a No Start issue unless I sprayed down the plug hole. Then it would run only at high throttl settings. It would not start 5 minutes later I primed and primed no start. So is it possible I can clean with soap and water and possibly clean it out or is it ready for the...

Where are these rubber check valves????

Can spray carb cleaner be used to clean internaly a Zama W-26 Carb????