I made sure with the new gasket that the impulse hole was not covered. No luck though.
As I’m no expert with small engine carbs or carbs for any matter. Is the fuel supposed to come through the impulse hole when it is being primed?
yea I cracked the original engine. This new engine had to have the valves adjusted right away. It’s got the new carb and new fuel lines with air purged out. I’m stumped because if I thought it was spark, it would come on at all.
I have a 32cc leaf blower that I replaced the short block on. I finally got it together but it wouldn’t start. I sprayed carb cleaner into the carb and it turned on right away. It ran for 5 seconds to reach full throttle then shuts off. I did not touch the throttle in this process. I replaced...
Hey guys,
I replaced my short block after the last one cracked.
I got it all together and started it to break the pawl. I bought another pawl but wanted to ask if the engine is setup right before I mess up another pawl trying to start it.
The cord was hard to pull because it felt as if it was...