Recent content by efair

I just finished reverse engineering the wiring diagram for the subject mower, it is attached. The A inside a circle denotes the four position connector.

Sorry - should've said "In the bottom right corner of illustration 7". That is what confuses me.

Thank you rivets, this is most helpful. I will try the procedure today. On page 27 it says the below, but uses some terms that are confusing or not defined: Just curious having never disassembled one: Is the shaft shown in the first screenshot the same shaft that exits the crankcase? Am I...

This is a TVM140-70416M engine on a snapper type 10 mower on a just recently inherited non-runner. It has the Type 1 carbeurator. I changed the plug and it would start, but it wouldn't run under high-ish load. I disassembled, cleaned, then reassembled the carb. I have a rebuild kit in hand...

I'm new to this engine, it is 15 years old and just recently came into the family as a basket case. It was running pretty good for a few days but started surging badly yesterday after I repaired the muffler. I somehow knocked the governed idle screw off! Amazingly, the engine started and...