Recent content by dirtyharry

That did it. Thanks again.

I think we have a winner. I was looking at that wondering how the battery voltage was getting to the ignition switch without the solenoid being engaged. The schematic also shows several connections at the main battery terminal. I'll try that in a bit. Thanks again

I don't see anything resembling a fusible link between the solenoid and the fuse block.

Thank you.

I did pull them and clean the terminals. I also switched them around. It ran fine last week. I even pulled the engine cover to make sure mice didn't chew any wires.

My x300 has no power to the ignition switch. Battery is fully charged and mower will start if i jump the solenoid. I checked all the fuses and safety switches. The ignition switch checks out too. No power at any of the terminals. The fuse block is a little confusing. It has 3 fuses, 15, 20 and...