dawgn86's latest activity
-
dawgn86 replied to the thread Stupid Craftsman Dust Blocker Bag question ?? !.Try pressure washing it. -
dawgn86 replied to the thread Stupid Craftsman Dust Blocker Bag question ?? !.
-
dawgn86 reacted to Tiger Small Engine's post in the thread Craftsman Riding mower 22 HP 42 cut. Cant get tranny to disengage to push mower. with
Like.
Occasionally the bypass sticks on these transaxles. Follow the release wire under the machine to the bypass lever on the side of... -
dawgn86 reacted to tonymy01's post in the thread Repairs Smart Drive Pin not staying engaged... with Like.
Ok, I worked it out after pulling apart and assembling it at least 5 times. 1. Doing it without the cable connected to the gearbox is...
-
dawgn86 replied to the thread Craftsman T3000 Lawn Tractor wont manually roll.So I went and got the lawn tractor today. Was able to get in in freewheel and rolled onto my trailer. I checked plugs, oil level, etc...
-
dawgn86 reacted to bertsmobile1's post in the thread Craftsman T3000 Lawn Tractor wont manually roll with Like.
raise the rear both wheels off the ground and try to turn them If they turn in opposite directions then the clutch pads have rusted...
-
dawgn86 reacted to StarTech's post in the thread Craftsman T3000 Lawn Tractor wont manually roll with Like.
Bert this is a General Transmissions RS800. The brake is internal so there is no operator way of accessing it easily. Matter of fact GTI...
-
Good afternoon, I have been gifted a Craftsman lawn tractor from my in-laws and need to get it home to service, etc. Looks like a 2014...
-
dawgn86 replied to the thread Repairs Smart Drive Pin not staying engaged....I replaced the smart drive cable on my Honda last spring and that handle is a pain to get reassembled again. It took me a few tries, but...
-
dawgn86 replied to the thread HRR216, Cleaned shaft, still won't roll backwards.I did this to my 10 year old Honda last spring. Took everything out, replaced the belt, pinion gears and changed the transmission oil...