Recent content by CV63sami0812
-
MCCULLOCH d152 32cc
Thanks, I check it again. I'll also recheck the fuel return where it reenters the tank. Seems like the grommet seal is missing and the fuel is just the port. Could it fuelnpressure loss?- CV63sami0812
- Post #3
- Forum: Small Engine & Mower Repair
-
MCCULLOCH d152 32cc
Purchased Carburetor rebuild kit and installed carburetor the rebuild kit to include gaskets, spring, needle valve and associated parts. All the fuel lines and the primer bulb replaced Trimmer still stalls after about 10 seconds Running. I replaced the sparkplug with a D8J, the original was a...- CV63sami0812
- Thread
- Replies: 2
- Forum: Small Engine & Mower Repair
-
Purchased Carburetor rebuild kit and installed carburetor the rebuild kit to include gaskets...
Purchased Carburetor rebuild kit and installed carburetor the rebuild kit to include gaskets, spring, needle valve and associated parts. All the fuel lines and the primer bulb replaced Trimmer still stalls after about 10 seconds. I replaced the sparkplug with a D8J, the original was a RD8J. The...- CV63sami0812
- Profile post comment
-
-
-
-
Attachments Craftsman Snowblower
Have an old craftsman snowblower, just wondering what this hose on line is that combining off engine. It's it some type of crankcase over pressure vent or scavenging port??? Reference attached photos. Thanks- CV63sami0812
- Thread
- craftsman
- Replies: 3
- Forum: Other Brands
-
McCulloch D152 weed Trimmer
CV63sami0812 2 minutes ago I have a McCulloch D152 Weed trimmer. Sat for a few year, cleaned carburetor. Replaced sparkplug, fuel lines and primer bulb which were all dry rotted or brittle. The trimmer will start, run for a few seconds then stalls. Any tips??? Thanks CV63sami0812 Report •••- CV63sami0812
- Thread
- Replies: 1
- Forum: McCulloch
-
I have a McCulloch D152 Weed trimmer. Sat for a few year, cleaned carburetor. Replaced...
I have a McCulloch D152 Weed trimmer. Sat for a few year, cleaned carburetor. Replaced sparkplug, fuel lines and primer bulb which were all dry rotted or brittle. The trimmer will start, run for a few seconds then stalls. Any tips??? Thanks CV63sami0812- CV63sami0812
- Profile post
-
Troy- built TuffCut 230
I have a Troy- built TuffCut 230 21" cut 6.75 hp eith smart touch push lever starting. Cleaned carburetor, plug, changed oil and primer bulb. When I can get it to start it runs awesome; however the problem is getting it started. Seems like the starter does not have enough recoil wind to fully...- CV63sami0812
- Thread
- Replies: 0
- Forum: Small Engine & Mower Repair
-
Engine died and will now not crank Hustler Raptor 42" FR651VR engine Model 931741 serial number 13011560
Check fuses, especially battery charging fuse, check fan belt if there is one either replace or tighten. Battery could be not charging dropping out low voltage shutdown relay or switch.- CV63sami0812
- Post #18
- Forum: Hustler
-
Someone help me with this push button start -TB230
What is the next step. I have the exact same model. Troy-built TB30 Tuff cut smart touch push lever starting system. Plug, fuel, air all good starts sometimes and runs great when it starts. The symptom are exactly the same as the others that are previously described. Seems like to me there is...- CV63sami0812
- Post #10
- Forum: Troy-Bilt