Recent content by cruizertoo

  1. C

    help with model number

    Thanks for all the replys, you guys are good and fast
  2. C

    help with model number

  3. C

    help with model number

    hi guys, i have a yardman by mtd, i bought used, someone pulled the model number sticker off from under the seat, the tractor decals say " yardman by mtd, auto drive, 22hp 50" cut, garden tractor" the engine is a b&s model 407777 type 0128 E1 code 000818 YH. It is yellow and green...
  4. C

    gxv 140-135 cm3 , leaks oil

    My hr 215 sx, gxv 140-135 was leaking oil from the bottom of the crank shaft, I removed the old seal, went to the local mower repair shop and bought part # 91201-zg9-u71 and was told that was the replacement seal even though it was thicker than the old seal, I destroyed the new seal trying...
  5. C

    carb rebuild kit

    Hi, I have a homlite mighty lite 26cs string trimmer model ut 21506, the lettering on the carb is rui ing, is there a rebuild kit for this?
  6. C

    Blower will idle but shuts off if you touch the gas

    Hi, I have a sears best/ craftsman blower, vac mulcher 32cc, 170 mph, 360 cfm. with a walbro carb wa219b. I have done a rebuild on the carb, only has one removable needle. at two turns out the blower will run at idle but as soon as you touch the gas it dies. What am I missing?
  7. C

    gas soaked air filter

    after replacing the float, needle and seat, and taking apart and putting together about 4 times, the Tecumseh carb still leaks, What am I missing? any suggestions
  8. C

    B&S 22hp Intek twin valve, bent push rod

    I have a yard machine with a B&S 22hp (family YBSXS-7242BF) Intek Twin, First time out Was running fine then backfired, now running on one cylinder, removed overhead valve cover to find a bent pushrod ( right side cylinder, bottom rod). What might have caused this? and what is the gap when...
Top