Craftsman Garage's latest activity
-
Craftsman Garage replied to the thread Ariens 915268 Ikon 42 zero turn No crank !.Do you have this stored somewhere, and then copy and paste it whenever there is an electrical issue? lol -
Craftsman Garage reacted to Mower Man Dan's post in the thread Cub Cadet XT2 decision time- new or used? with
Like.
My neighbor had it and he bought it new and then gave it to me probably 10 years or more ago. -
Craftsman Garage reacted to Auto Doc's's post in the thread Is the x350 over-kill for my yard? with Like.
Hello M. Avoid buying a display model that has been sitting. Fuel goes bad in the carburetor and the battery discharges. Aside from...
-
Craftsman Garage reacted to Auto Doc's's post in the thread Ariens 915268 Ikon 42 zero turn No crank ! with Like.
If it has a low oil switch it will not prevent cranking the engine over. It will just not let it start and run. Worn out ignition...
-
Craftsman Garage replied to the thread E180 Transmission ?.definitely look at the K57 or K58
-
No, the K92 is a horizontal drive transaxle. Check out the K58. It has 217 ft lb torque where the K46 has 171 ft lb torque and K57 has...
-
Craftsman Garage replied to the thread Cub Cadet XT2 decision time- new or used?.Hey, I would do that. The trip would be well worth it IMO. Husqvarnas tend to keep their value similar to JD. Did you buy your Riding...
-
Craftsman Garage reacted to Tiger Small Engine's post in the thread Now the mower will not crank! with Like.
I use Permatex Right Stuff and have had great results with it.
-
Craftsman Garage reacted to Auto Doc's's post in the thread Now the mower will not crank! with Like.
I like it when a DIY type uses clear bathtub silicone and then wonders why it still leaks. LOL
-
I have genuine 1-1/8 V-belt drive pulley from Craftsman rider if you are interested. It has the crank key made into it.
-
Craftsman Garage replied to the thread Kohler Command CV22 throttle linkage no response.Incorrect setup, cable needs to be set, or need heavier throttle spring.
-
Craftsman Garage reacted to Rivets's post in the thread Kohler Command CV22 throttle linkage no response with Like.
I suspect that the linkages are not hooked up correctly. This manual should help you double check your assemblies...
-
Craftsman Garage replied to the thread Belt keeps popping off..That probably bent the frame mounts if I had to guess.
-
Thanks very much for all the detailed replies. I'm going to take the tractor apart while waiting for the new belt to arrive and will...
-
Bull I personally know it matters as I maintained Husqvarna HWT625s for a local nursery where belt being off a by 1/4 caused problems...