Craftsman Garage's latest activity

As I once told my idiot brother that said questions I asked were stupid. At I least admit I don't know everything and asking questions...

Also, most of today's teens don't set the bar very high. Just saying... ;)

I'm proud of being in that minority 😁. As someone who was self taught, working on engines can be stressful at times and it's a lot when...

Before you touch the engine again you must get yourself a good understanding of all things which make an engine run. To do this I...

I have to disagree here. There are times that a governor can cause surging especially with systems that has too much slop in the system...

I forgot to mention this, but this transaxle I want to rebuild to swap into my Craftsman Pro Series T7400 to replace the continuously...

And the battle of the oils begins....a very slippery subject.

I don't know much about oil but i do know my oil is better than Scrub's oil.😁

I found this video very interesting.

No doubt, yours broke the compression release.

This may be my unpopular opinion, but this is the 3rd Tuff Torq (2 K46, this K57) that I have rebuilt, and I find it pretty easy and...

I found the culprit. Jammed belt. I didn't see it until I removed the back wheel. Thanks

Thanks, Do you know which filter is better, the older paper or the newer mesh one?

Cavitation... You need at least a seal kit 1A646099151 or if center section and pump motor(s) are a repair kit. 1A646098420 When...

Hi guys, I have a Tuff Torq K57 from a Husqvarna YTH24K48 and was wondering what is involved to rebuild it? I just want it to be...