Recent content by Codyl74

It was hydrolocked with thick oil. Pulled valve cover and there was thick oil pooled up there. I poured 6-8 ounces of gas in the plug oil and let it sit for a few minutes. I pulled the cord and it shot out gas and oil, kept cycling until I got no more liquid coming out. The gas thinned the oil...

yea but that doesn't explain the pull sticking with plug in and smooth out. Yea then no hydrolock. checking the valves today

There is a needle valve on fuel line that was left open now that I think of it. I get where your going, keep it closed. Maybe hydrolocked now?

Yes two mounts broke and I replaced them. engine and motor bounced around inside generator frame when it rolled.

It pulls and rotates fine with plug out, so a compression issue right? Im far from a mechanic. Will look at valves today.

Briggs and Stratton 10ohv generator. I was moving the generator with a dolly, it falls off and rolls over sits upside down for about 15 seconds. I had to order new rubber shoes so it sat right side up for a week. It starts just fine and I run it for 20 seconds and when I turn off it shakes...