I would definitely use thread locking compound, alignment is critical for a happy joint but there's not a lot of room for a straight edge/small machinist square to ensure this, as recommended by the mfgr's documentation so I just used the method as described. Low noise & vibration is my goal.I...
I put my readers on and read the fine print ,
"Jig-a-Loo Extreme Graphite"
"Contains: Acetone, propane & isopropanol
Will affect some plastics & paint."
A moment with Google shows me that Nylon is not seriously degraded by any of these 3 chemicals.
Whew.
Thanks for the heads up, I used graphite spray lube.It was on hand.
It uses a very thin solvent carrier that evaporates in seconds, it didn't occur to me to check for compatibility....
So far so good..
The wire arrived, interesting job taking the curve/bend out of the length needed.
Then I noticed that there was a mirror so to speak for the carb linkage not only
allows for a left hand approach but also raises the pushrod/cable housing a couple of inches
off of the nasty old...