Recent content by Burk62450

i had a mantis tiller and it had spotting rust on flywheel. couldnt figure out what was going on with it. finally cleaned the rust spots off and it fired and ran as it should. i did notice that using my ohm meter i would loose conection when i went over the spots with rust. i read a forum one...

poulan saws are really bad about bad fuel lines. the crack break and allow air into the system making it not want to rev up and almost impossible to adjust. first thing i do with them is replace fuel lines and primimer if the unit has one. far as the scoring on the piston you mentioned, if it...

is the magnet on the flywheel rusty at all? how bout the ignition module, rust or debis on it? also have you checked the air gap. saw where you said it had good spark but what did you test that with, sometimes grounding the plug is not suffitiant

have you tried putting a carb kit on it. may just have a bad diaphram. if you think the jet is bent throw a carb on it. personally i would look on ebay for a carb for it. they shouldnt be too awful bad to get one.

ok i have a 2020 troy bilt super bronco. starts and runs fine for three wees, one day a week starting and running high idle or mowing for 1-2hrs. on the fourth week like clockwork the mower will not start it will only click. jumped mower and runs fine. used meter and tested -batt to -cable and...