Recent content by bouncer959

There is a fuse in the starter circuit, I’d check that first. Sometimes they are hard to find. If not bad, it could very well be yours new solenoid. I had am customer with a fairly new DR Chipper brush cutter that had exactly he same symptoms. It would blow fuse, but then stopped blowing...

There may have been a key in the large pulley yor worked on the previous week. Key could have fallen out of its slot un noticed and pulley is slipping on the shaft. My 27 hp Craftsman DGT6000 hydrostatic did the same thing, would pull but would not run at top speed or pull on an incline. I was...

I checked cap vent, opened it up, loosened cap, it will run about five minutes or so then try to quit. If you let it idle when it starts acting up, then it will run another five minutes maybe then quit altogether. It starts back up pretty easy. Bulb is full of gas. It acts like a coil...

So the tank is not pressurized? I guess not since the new fuel line kit comes with a tank vent hose that just goes straight down into the tank and has what looks like a check valve/ filter looking apparatus that is outside the tank.....

I have a Husqvarna 125 BT backpack blower. I have replaced carburetor, fuel lines, fuel filter, tank fuel line seal and spark plug. Will run for about ten minutes with a full tank of fuel, then dies. Will crank back up, but quits again quickly. Will run again for about ten min or so if you...

Hi guys! . I have a 27 hp Kohler Command twin Cyl in a Craftsman mower. When the engine gets hot after say, 45 mins of mowing, it's starts stumbling or flooding when you hit a dough place in the yard. I also notice it doing it on a sidelong place leaning to the right. I've rebuilt the carb...

I have a Craftsman with a 27 HP Kohler engine. I've installed a new Carb kit, cleaned Carb, engine stumbles or floods when engine is hot when you hit a rough place or slope of yard is downhill to the right. I took carb back off to adjust float level, having forgotten that it has a plastic...