Thank you! Took about 5 seconds with a pair of wire-cutters to correct my problem for the day. I'll properly clean out that connector with the spring-loaded conductor inside - later in the week. I bet there's dirt/grass that prevented it from losing connection when it was plugged into the...
Thank you - That gives me a good spot to start tomorrow. The connector looks good - I haven't removed the seat, yet to access the button on the seat switch. I didn't realize there was a connector INSIDE the harness connector itself - so that explains a continuity when it's disconnected from...
The only thing coming to mind - is the seat switch circuit. Mine is the 2-wire switch (as shown in the diagram above).... so in theory - if I simply unplug it from the harness - it *should* allow the magneto to not ground out... Just tested that theory - and it still kills the engine when...
I was wrong. Yesterday - at the end of the day - something "happened" to work right, and I got the mower onto my trailer. Got to my client's field this morning (appx 18 deg. F) - and AGAIN - couldn't release the brake again without the engine cutting out. Frustrating - but ya gotta do what...
Fixed. On the lower right side of the dash - there's a big green button with a picture of as mower and a forward arrow on it. That button (switch?) is for "Cruise Control" -which- until today - I had no idea was on this old beast. After pulling up the button/switch - it allowed me to...
It's too cold to mess with it today - even though I just went out and warmed up the engine again - and confirmed that yes - it DOES shut down when I let off the brake. I looked under the brake pedal, and saw a wire harness connector there - so I'll investigate later today (after lunch).
As a...
I have a quick question regarding safeties in sub-freezing weather. I have an OLD snapper LT125 - that I recently upgraded the pulse fuel pump to an electric fuel pump (and it runs SOOO much better now!!)
I typically use this mower as an ATV (with a pull-behind cart) to move equipment and...