Recent content by bobknowverylittle

Will check venting tubes and caps, seems odd both tanks would be doing same, as one has never been used. Thanks.

Star Tech, just discovered something strange, there is no accumulation of fuel in new filter. Put gas in other side tank, still same problem. Engine still starts no problem and idles fine. When i full throttle in neutral MIL light comes on for a short period and goes off. When i turn the key on...

I had been told that. Thanks again, I will look up manuals to see if i can get one,

Thanks Star Tech. Can anyone individual order or buy the tool kit? i assume the manuals can be ordered also?

Thanks for your input slomo, it is appreciated. The problem is still on and off. Changed fuel filter, main filter, seem to have helped some, also switched fuel tank caps from other side ( never used) I did find an additional filter connected to the fuel tank, but has only hose on one end (part #...

I didn't tie the fuse for the fuel pump into this problem. When i changed the fuse the pump came on when turning ignition and is still coming on and starting fine, seems to run well at full throttle, only when i engage the PTO. I could not get it to fail today. Tried it three times and it ran at...

Don't have any code panel, that i know of. Unless it appears on hour gauge when happening. Went to see if anything on hour gauge and could not get it to fail today? Feel certain it will show up again!

Snapper Pro S200xt, 49E877 vanguard engine EFI system. As mentioned, engine bogs down when turning on the PTO. Just started doing that two cuts ago. Turned off engine to check for debris and or bad pulley, they were fine. Started engine again and problem went away, cut grass. Same thing happen...

Yes, generally blow with air nozzle along with air filters after each use. From video did find one small fuse under shroud that was bad. Worked fine for two cuttings then now having engine rpms drop when engaging the pto twice just turned off engine to check for debris and pulley bearing...