bk10s's latest activity

LESSON LEARNED.....DON'T ASSUME. I have owned several Broadmoors over the years, beginning with a 728 that I bought new and still own...

It does not have sealed bearings. The rollers just spin on the axle shaft.

I also notice that I have the chains attached to the slot of the curved part of the shaft assembly. The owner's manual shows the chains...

I will check the front height of the deck.

I will try the second link on the chains. Will the rollers reach the ground? I understand about the bar and adjusting front deck height...

Nothing in the owner's manual except how to raise and lower....With the toggle switch on the dash!

Thank you. It has the Simplicity blades.

I have a 50" electric lift deck (1695392) on a Prestige (2691130-00). The maximum that the cutting height can be raised is to 2.5". Is...

I was able to perform the procedure and it now idles perfectly. Thank you to all!!

Cold idle is 1750, warmed up 2100. Cooling fins and linkages are all clear of grass and debris. Do I need a special tool to adjust tangs?

Should this Idle Adjustment procedure be performed when the engine is cold or hot after mowing (When idle is elevated)? Thank you!

Thank you, ILENGINE. Is the warping of the plastic intake manifold a symptom of something else? How difficult is it to replace? Thank...

Hello - I have a Briggs 27 (13 0417 YG 23649) on a Simplicity Prestige (2691130-00) and when I start the engine it idles about 1700 rpm...