Recent content by Bbrayden85

I had already dumped some in the cup as well as rubbed some on the crank when assembling it.

Thank you. Already ordered a new key and will try that. Thank you for your time!

I did not torque it because i do not have the special tool to tighten down the clutch. It uses the pullstart clutch to hold the flywheel down

My flywheel key is sheered. That makes sense because it did run for a few seconds before backfiring and not running again. What could have caused it to shear so this doesn’t happen again?

So i have a briggs and stratton model 100202-0472-01 that is on an air compressor. It ran before this but i decided to rebuild this engine. I lapped the valves, and honed the cylinder. Before this the engine used a points system. So i bought a magneto to get rid of all that. Its tge exact same...