Recent content by bamadirtrider

Update: We installed the clutch following the guidelines in the install pages AND those that were presented here! He is cutting grass as I type this and wanted to thank everyone for the help in troubleshooting the issue and install guidance!! It was much appreciated! I add my thanks as well!

Question: His appears to be a CCW Clutch (Pulley down - Toward the ground and clutch toward engine case. He has the Special-Washer which is about 1/4 inch wide!(His Does Not have the D-Spacer!). He can't figure out how to hold the assembly in order to torque the bolt??? I watched about every...

Awesome info. Might have just saved him some extra dough! Appreciate it.

Appreciate that info. Will tell my neighbor to read up some before attempting replacement!

Thanks for the help. Will do.

it is a Model: STCII-61V-32BV S/N: R3100200

He put an inline fuse of 7.5A in circuit and blew it immediately: the blades didn't even try to turn. So He'll be ordering a clutch. Thanks for the info. Now to find the best deal on a clutch. Any suggestions/recommendations appreciated!

Certainly appreciate all that helpful information! Had I wanted to get blistered like that I would have attended a Don Rickles show and sat right down front. If you need help in how to just roll on by a post you have an issue with and can't use a civil tone I can carve out about 6 months to...

He only cuts to 2.5 inches and never lets grass grow long. The company he retired from hired him to maintain the landscape and pay him by the hour so as to speed . . . LOL.

5 years and just over 500 hours.

Friend has a SCAG Tiger Cat 61. Switched the PTO on and blew a 20 amp fuse on the right fuel cell Immediately. Didn't actuate the deck at all. Replaced it and blew again with no deck action. Put another fuse in so he could get it home(Its cranks up & drives no problem). He then placed another...