Auto Doc's's latest activity

Hello A., I run propane tractors and generators. All of them call for a closer gap of .026 inch so the propane will fire properly under...

Hello D., I converted both of my small generators to a gasoline/ propane combo a couple of year ago. Yes, they are much harder to start...

A typical small engine like this one will make 60 PSI on a compression gauge after about 4-5 pulls. The compression release mechanism...

The adapter is intended to hold the crank while the center bolt is tightened. I recommend you install it on the new replacement clutch...

Just from my experience... I have 2 generators with this same 10HP OHV engine. One was a new replacement engine that was equipped with a...

Is this a generator application? Hard to tell from the picture. Is a 1 or 2 pull to start that challenging? If so, the carburetor is...

Looking at a picture of the tank, the fill neck is off to the side and shallow.

This tank is hidden in the rear of the chassis and there are no provisions to add a fuel sender and gauge without some serious...

Please provide the chassis PIN label information so we can get better details in the parts and service information. JD did not build the...

I suspect a drive pulley or a belt is failing. Here is an exploded view of the parts...

The typical life of any battery depends on how it is maintained. If I had to put a number to it, I would say at least 5 years with...

These are what I like to call a "gotcha filter". Some repair shop techs do not even know they are in there. Most of the time they can be...

I suspect the carburetor diaphragm has become stiff from age, and the needle will not work properly. For most, I just order a...

Spray each exhaust outlet pipe with a spray bottle of water and see if they both burn of quickly. This sound like one cylinder is losing...

Hello C., There are many design variables involved so pressures and gallons per minute (GPM) will be different. I suggest you study...