Auto Doc's's latest activity

Hi Scrubcadet 10, That is the one I'm referring to. Also be aware that the tiny O-rings need a little bit of light lube, so they slip...

Hi Scrub Cadet, From watching your video, this is a bleed air jet problem. Have the valves been checked for proper adjustment and to...

Place a short board against the starter base and tap it a little with a hammer. Do not hit it hard, because you risk breaking the field...

Pull the plug and the crank start head and then rotate the motor by hand with the flywheel to see where the flywheel magnet meets the...

https://www.partstree.com/models/fr651v-es34-kawasaki-engine/?msclkid=02462298602a1045b36b4bb64cf255da

Hello J., The diode is likely placed inline under some black shrink take and it is blown/fractured internally from a shorted warning...

Hi StarTech, I currently have a Kohler CV-22 here doing similar things. Even though the cable is adjusted correctly, the choke blade...

Lower end is in place and the upper end is nearly impossible to become dislodge due to the Z end. Normally it would require removing the...

The choke is manually operated by linkage on most machines. The vacuum of the engine has nothing to do with it. Get the correct...

With the key on, can you ground the sender wire, and the light comes on? If it does not, there as a power wire broken going to the...

I have been in South Texas since 1988, but I worked on a lot of snow blowers when I lived in central Va. previously. Usually, the damage...

Snow blowers don't do well with rocks; it likely bent the auger/rotor. You need a visual inspection to see what is going on. Stay away...

Removed the air cleaner and backing to see the actual choke plate. You may have to pull the entire upper fan shroud off. The linkage rod...

Was the throttle cable takes off of this at some point?

That is my point to the OP.