Auto Doc's's latest activity

Hello Piney, I recommend a non-serviceable trans for that small of a property. I do not recommend pulling any heavily loaded through...

Hi Breton Lion, Are you using an adjustable gap spark tester? Did you remove the top cover an disconnect the coil kill wire? Did you...

These engines have an aluminum tag riveted to the very top of the metal fan shroud. Pretty easy to find the model and type numbers.

StarTech, They are going to have to peen lightly with a center punch them in the center to lock them in.

The full model number got left out of your picture,

You read Amps or Volts? Wire diagrams are not always 100% inclusive on some models. Other mowers may have had the same harness with...

Hello BAM66, Have you tried running a power and ground directly to the clutch connector wires to confirm it has failed? These were some...

Hi ljb, Pull the plug wires and crank the engine a few times while the drain plug is out, then let it sit and drain a little longer...

Hello R Williams, For the welch plug, you can fashion one out of a tiny piece of aluminum that will fit the hole, then put little bit...

You have an odd one when it comes to riders. Remove the top engine cover and disconnect the single wire coming from the harness, that...

Possibly the pull start engage levers are not fully releasing or there is debris under the fan shroud. If it were serious the engine...

If it had wheels, they would have been mounted on front backets on each side. All I find online is they have a free floating deck.

Hello Kenneth2, I suspect valve adjustment was way overdue. That happens a lot. Also, a possible overheat would stick a valve and...

One thing is for sure, foam filled tires ride very hard, and all that extra shock is transferred into the implement pins. Calcium mix...

The bolts usually line up, but the 14HP head gasket has to match the 18HP head combustion chamber exact. If not, a gasket failure will...