Auto Doc's's latest activity

Pictures would help. Maybe some parts views will help...

Hello ACF, All JD mower equipment comes with a durable product identification number (PIN). Some are fairly well hidden on the frame...

Hello rh hutchins, Sounds like pivot parts stiffened up from sitting and they need to be exercised & lubed carefully (WD-40) to get...

Look under the seat and give us your model and serial number, so we can help you with references if needed. Cab Cadet also provides...

From you description I would suspect there is low compression. Maybe the valves need to be checked for proper seating. Carbon does build...

Sounds good

Usually, I prefer not to dry out a carburetor because the Viton tip on the needle and seat get dry and rigid. They have a hard time...

Hi kmills74, It is unusual for the valve lash to actually get tighter, normally they get wider to a point where a push rod ends up...

I learned when I did my Z-Force 48" deck belts that the PTO belt can easily fit on the wrong side of the deck idler and tensioner. The...

Hello kmills74, If you have a good compression tester, make sure the Shrader valve is snug in the tip of the hose and use the...

Hi Tiger SE, I think we both know "common sense" is not common anymore. I grew up in a poor family where we had to keep everything...

Sounds like rust got into the nuts on the hose fittings. Usually one end is crimped solid, but the other should be able to turn on the...

You might contact Jack's small engine and talk to them to see if they can find you a used one.

Can you provide the product label information for the Toro you have. If it is a bagger model, the label will be under a bagger door at...

The pinion and rack gear need to be replaced most likely. The deck has to be removed, and the mower raised up enough for access to the...