Auto Doc's's latest activity

Sounds good

Usually, I prefer not to dry out a carburetor because the Viton tip on the needle and seat get dry and rigid. They have a hard time...

Hi kmills74, It is unusual for the valve lash to actually get tighter, normally they get wider to a point where a push rod ends up...

I learned when I did my Z-Force 48" deck belts that the PTO belt can easily fit on the wrong side of the deck idler and tensioner. The...

Hello kmills74, If you have a good compression tester, make sure the Shrader valve is snug in the tip of the hose and use the...

Hi Tiger SE, I think we both know "common sense" is not common anymore. I grew up in a poor family where we had to keep everything...

I ride a Harley trike but cans and glass in the road are not good for any tires. Grass clippings are usually harmless for me. The guys...

Sounds like rust got into the nuts on the hose fittings. Usually one end is crimped solid, but the other should be able to turn on the...

You might contact Jack's small engine and talk to them to see if they can find you a used one.

Can you provide the product label information for the Toro you have. If it is a bagger model, the label will be under a bagger door at...

The pinion and rack gear need to be replaced most likely. The deck has to be removed, and the mower raised up enough for access to the...

There should be a diagram label on the top left front side of the deck (As seated on the machine) Cub Cadet.com should have the manuals...

First, what is the product label numbers on your machine. It should be under the seat. They made a variety of this model. Cub Cadet.com...

Hi Forest#2, The OP is working on a B&S twin not an Onan, but it is good information to know. I occasionally see Onan generators in...

Take the carburetor off and make sure the throttle blade has not come off the shaft.