Auto Doc's's latest activity

First, always use distilled water. It works really well by itself in an ultrasonic tank. Just for good measure though I add a splash...

Please provide the engine model and type numbers stamped into the valve cover (B&S) or on the label if it is a Kohler engine. The...

What part are you having trouble with, reference the diagrams...

Hello Mattmotors, This carburetor design was used on many different applications, so the parts like the choke lever would be different...

Check the fuel shutoff solenoid at the bottom of the fuel bowl. The pintle is likely stuck or the solenoid has failed. Water is not kind...

Hello hek2000, Welcome to the forum. We need the product label information so we can look up what you are working on. Snapper made...

This favors blades out of balance or very worn spindle bearings. The tensioner idler will jump back and forth, that is normal. As for a...

Don't expect the puller to be in the Briggs and Stratton manual, they did not build the mower, just the basic engine. The manual that...

We need the stamped number information off of the valve cover. There were different intakes used on many models. Model and type number...

Rotary is a supplier.

I would suspect the coil, especially if the problem gets worse with heating up. The plug may be questionable if it was purchased online...

Sounds like the tank is not venting properly. On older mowers they vented through the fill cap. On newer mowers they have a one-way...

Service manual says to turn crank shaft so rod journal is at 9 o'clock.

Have you inspected for damage from where it got stuck and then pulled out? Something got bent from what you are describing.

I think this is going to lead you back to a servicing dealer on this one. I searched several sites and parts are elusive through most...