Auto Doc's's latest activity

I say cut at 2-1/2. There is no safe way to alter the factory design for personal vanity.

Hi grantiman, I forgot to mention earlier: One problem that I am seeing more of is the fuel shutoff (after fire) solenoid harness...

Hello Its Me, I prove the numbers and also have customers purchase the big-ticket stuff from known sources these days to protect...

Hello sano888, A brass bristle brush is ideal for cleaning exposed switch terminals. "Polishing" them is overkill. Just expose clean...

Maybe they forgot that they posted a help request? I give people benefit of the doubt. (Got bigger things to worry about in life)

As these engine run, the moving valve parts wear a small fraction of an amount and the valve lash open up too much, which makes...

Hello, Tiger Small Engine, I used to only buy new engines from small engine warehouse online, but they have gotten out of hand with...

Hi BrentW, I think that would be a wise move. When you open the new spindle assemblies up, you might be surprised. Pre-assembled...

Did you give them the engine model and type number off the engine? If not, they just looked it up by the machine model number. These...

Is the governor link hooked to the throttle? An engine cannot run wide open with a closed throttle. Are you sure the governor adjustment...

I think some of the difference comes down to how the 2 machines are wired. This Murray (white wire) has to pass through the two safety...

Have you actually looked at the carburetor throttle plate? I have seen them come off and get trapped in the intake port before. That is...

Thanks to all the folks that have stuck with this issue and finally hammered it out (I hope). So far, knock on wood, everything has...

Ebay turns up with good used rider engines pretty often. Most people trash their mower decks long before the engine breaks down...

Most likely the battery or a corroded cable connection from sitting. A multimeter will only measure the voltage potential, not the...