Auto Doc's's latest activity

Sorry to hear your trouble, this was a poor design idea for Ryobi.

Sorry to hear your trouble, this was a poor design idea for Ryobi.

They all have a certain amount of rubber compound to hold the strengthening material such as Aramid or Kevlar. The 8-ten belts are very...

The intake to head mounting gaskets or O-rings are possibly leaking. What appear to be a plug on the bottom of the intake is not...

Cut the key off in the future. If you are worried about your last oil change interval, change the oil and start your count over, no...

Replace both, but get them from Parts Direct or Jack's Small engine. Avoid Amazon. Ebay is also good but look for genuine parts. Just...

Glad to hear you got it working. Never trust a ground that "looks" good.

For both coils to fail at the same time is highly unlikely. Usually, a reduction in power is quickly noticed, but not a total shutdown...

For both coils to fail at the same time is highly unlikely. Usually, a reduction in power is quickly noticed, but not a total shutdown...

Check for a broken ground (black wire) that doubles from the headlights and back to the start solenoid. I have seen that strange wiring...

Hello Packman88, This site does get clunky and lags at times, so be aware of that.... I own a 1988 Snapper RER with a 30-inch cut and...

Make sure the long air cleaner bolt is in place before you make any air mixture adjustments. I usually start by lightly screwing the...

These tie rods have a couple of odd bends in them already. It would take a torch to heat the steering rod red hot, then a long prybar...

If the transmission has a growling/ buzzing noise when you try to move it, that means it has had a drive fluid loss more than likely, or...

Hi Tom, Lowe's has an area dealer send technicians out to uncrate and prepare the machines. The blade issue would be a factory assembly...