Recent content by albreton_

I was cleaning up my Husqvarna z254 and I found this little screw laying on the ground under the front end... any ideas?

I was cleaning up my Husqvarna z254 and this little screw fell out somewhere near the front end near casters, I looked and didn’t find anything on the other side... any ideas?

Could of been an incident then. I got the mower as flipper and this is the first night so I’ll tinker with the adjustment screws for the carb and screw in that other screw back to normal

Yes there is a screw on the side, the engine was running poorly and I unscrewed 1/2 a turn and it ran nearly perfect. I know that hole is connected to the suction and air in the carb so could it be a air screw adjustment instead?

I have a scag 48’ with a Kawasaki fc420v. There is a small hole that is squirting out fuel when engine is running. There is a picture attached below but I can’t figure out what it is

This part fell out from the bottom of my craftsman zero turn zt7000 while trying to purge it. I have no clue what it is and the mower still only moves a slight bit when bars are all the way foward and backward. Left one works better than the right. What is this part?

This is the general mower number I couldn’t find any codes on the hydros

Yes agree check the fuel lines, change the gas and fill it up, and if there’s a fuel pump check it as well. Could be ignition but check fuel first. Sounds fuel related type problem

I’m thinking that is the governor return spring, follow the link that goes from the carb and ends at a L shaped bracket, there should be two holes that it hooks into near where the throttle cable ends.

That is called the fuel shut off solenoid, when the ignition is turned on the plunger on the end of the tip goes down and allows fuel to come into the bowl. The picture however looks like that was snipped meaning it is useless. This was probably done because of the electric issue your seeing...

I have a craftsman zt7000 and I was purging the hydros because they hardly moved, had a slight jerk when bars are all the way foward or back. During the purge I heard a soft metal on metal tap and didn’t think anything of it and then found a metal key with a flange on the end. The hydros still...