7394's latest activity

nope.

Look at those worm drive hose clamps. They tighten but do have gap at the screw area. I quit using them..

Yes the cylinder shaped l one, I doubt he does that. He said he just puts a new one on on once a year. I've offered to take care of his...

I just put my blades in vise, and use 60 grit flapwheel on drill...then cone balance First I soak them in pan of water for ez clean...

There are tons of threads on blade sharpening on this, as well as other sites.

How can spec be 3800 RPM when maximum for a small engine is 3600 RPM?

This why I wouldn't give up my 1970 era charger. Another option is a 12v solar panel to bring a surface charge of 7 volts or higher so...

2 or 10 would be fine. The issue to be away of is most of the modern chargers won't charge a completely dead battery. You have to have...

Utility knife cut off drain nipple quickly.

I used a Crow foot 1" socket to tighten mine. No engine loosening.

Just came across a new drain plug design on a KT725. Still a 3/8 NPT plug but they now have a T50 torx countersink and not the normal...