:newhere:Hey guys, neat forum.
I was cutting in thick grass today and my push mower (B&S 6hp engine) stalled. I started it up again and a few minutes later it stalled again. I waited a while, made sure nothing was stuck under the blades and started it up again.
Even though I went slowly it stalled yet again! This time, when I tried to start it, the pull cord handle wouldn't even move.
The handle(and cord) remain immobilized, it won't even move an inch when I try to pull on it.
Can you guys figure out what the problem is?:confused3:
Thanx, Tiff.
I was cutting in thick grass today and my push mower (B&S 6hp engine) stalled. I started it up again and a few minutes later it stalled again. I waited a while, made sure nothing was stuck under the blades and started it up again.
Even though I went slowly it stalled yet again! This time, when I tried to start it, the pull cord handle wouldn't even move.
The handle(and cord) remain immobilized, it won't even move an inch when I try to pull on it.
Can you guys figure out what the problem is?:confused3:
Thanx, Tiff.