Search results

Fixing a Hustler Fastrack 36" with a Kawi FH541 17hp for a friend, put in new carb and adjusted everything to run at 3600 WOT and a nice idle speed. Only problem is that when I turn off the engine, the governor does not go back all the way to the idle stop. So, when I go to start it again, I...

The starter on my Scag Wildcat 52 won't crank. Checked the safety switches, the relay, key switch, PTO switch, all checked out. Additionally, swapped a spare good key switch, no change. Swapped a good spare relay, no change. Removed starter and bench tested, works great. Tested green wire from...

I was looking online for information on greasing these aftermarket Oregon 82-325 Cast Iron Spindle replacement for Scag 46631 spindles, and I found a lot of conflicting information as to the construction and the corresponding greasing schedules for Oregon spindles. Most said all of Oregon's...

I replaced both ball joint rod ends on both the right and left Push arms and now the rear deck chains are angled somewhat forward, like the push arms are pushing the deck forward, is that OK, or should I screw in the rod ends further into the Push Arm till the deck chain is straight up and down...

I have a 2007 Scag Wildcat STWC52V-25KA, 52" with a Kawi 25hp which I bought from my neighbor about two months ago. The motor and the deck are newer like from 2014 and it sat like 2 years unused, so I bought it from him. I changed the engine and hydraulic oils & filters, changed the center...