Search results

Yes I read that and it appears the float valve is the culprit here. Although I was very careful when I took the float out to make sure the valve was mounted correctly and it was. It appeared to be fine although I guess it could have gotten stuck somehow. The tip seemed to be fine as well. I have...

Do you have an idea as to what caused all that fuel to end up in the crankcase?

I drained all that gasoline saturated oil out of the crankcase. I got a new float valve and am about to go through and clean the carb. In doing that I noticed that the solenoid on the fuel bowl doesn't release when I turn the key. Could this have caused the fuel to go into the crankcase. I'm not...

Scrubcadet, I realized my error after I responded. The mod # is 44m777. Not 40

Mistake!!!!! 44M777, makes a big difference I'm sure.

My mistake. It is 44M777.

I discovered my error. The mod # is 44m777

Star tech I can't believe I made such a mistake reading those numbers. It is clearly 44M777. I don't know why I kept saying 40 when I'm looking at 44.

No I just went out to verify. There is no question as they are very clear 44M777

I can imagine that float valve getting under that clip on the bracket without being under both sides. I will take it apart and check this before I do anything else. Then do a couple of oil changes.

Yes there is a clear "m" between the 40 and the 777. The type is 0110 and the code is 070424YG

No I double checked the level and had it right on the mark. However I just checked the dipstick and got a STRONG gasoline smell. I'm thinking that the float valve is somehow not shutting off. I'm going to open the carb and check it out and then drain the oil and replace with fresh and see if I...

Thanks for the info. Pulled the dipstick and it smells of gasoline strong !! Guess I should check the float valve before I try it again.

Thanks Rivets, I just pulled dipstick and it has a strong gasoline smell. I'm thinking the float valve is stuck open. So I will go back into the carb and confirm.

My thoughts on the carb were that since it had set up for a while it could use a clean out.

Just finish cleaning the carb on my B/S mod 40m777. It had been setting up for about two years. Carb cleaning went very well. Put it all back together, fired up just great but all of a sudden I've got a cloud of white smoke all over and a good bit of oil is being spewed out of exhaust. I shut...

Have a good weed whacker by Husqvarna. Briggs 6.25 hp engine. When I try to prime before starting the bulb is still soft after 3-6 times. Could the bulb be defective? Thanks for this forum, I just joined. Great to have thus source.