Search results

My clutch is reading 6.2 ohms. I am assuming it is going bad since when I mow for long periods of time it draws down by battery. The factory part number for the clutch is 604184. It currently has a Warner 5218-110 clutch on it. Since I purchased this mower used I'm not sure if this is the...

I have had this problem where when you pull the pto switch the blades dont always engage. Sometimes they will after a short delay other times I just keep trying the pto switch until they engage. When it is running with the blades off it shows 12v on the gage. This time after mowing for about...

if anybody has a grasshopper 327kw could you post a picture of the wiring harness plug and wires that connect the kawasaki engine to the grasshopper harness. the kawasaki plug has 6 wires and the grasshopper looks like it has 5. Thanks

My kubota diesel does not like to start when it is cold out (60's). Can you replace the glow plugs in these engines? If so does anyone know what the part number is or where they are available at. Thanks

Anyone have any information on how set up the safety switches for the steering arms? I recently replaced mine and I am having problems with the pto shutting down with the levers in. The mower will also start with the arms in,

I just installed a new deck on my 321d mid mount mower. I read thru the owners manual about leveling side to side and front to back and did what it said. Measuring the blade height is almost impossible when you have to measure the back side of the blade. I put a level across the mower deck...

I just had to replace my wiring harness in my 321d due to mice chewing the other harness. Now when I try to start the mower the only way I can get it to run is to hold the key switch in the start position. As soon as I release the switch the mower shuts off. I am pretty sure it is an...

I am still having problems with my 321d. It just shut off while I was mowing (it is intermittent). The mower restarted right away. Then while I was mowing you could hear the clutch cycling. I think it is an electrical issue. I am going to try and bypass the safety switch on the seat to see...

Can someone tell me what their grasshopper voltages are with the engine (preferrably a diesel enging) at idle, at full throttle and when the clutch is engaged at full throttle. I am trying to see if I am overcharging. Thanks

I have a 321d it has about 1300 hours. I have done alot of work to it since buying it used about 3 years ago. It recently started shutting down and I don't know why. The 1st time it did it I was mowing with the blades engaged. I adjusted all the belts thinking maybe this could be a contributor...

I have a 321d it has about 1300 hours. I have done alot of work to it since buying it used about 3 years ago. It recently started shutting down and I don't know why. The 1st time it did it I was mowing with the blades engaged. I adjusted all the belts thinking maybe this could be a...