Search results

have a kohler ch25 that runs but have noticed that power drops off, after running for a little bit compression is 125 and 115 one plug looks good but the other has the black soot on it could i have a bad coil on that side thanks

have a xt3200 dixie chopper does not want to pull correctly want to know what should be the level in the hydraulic tank and type of oil needed, and if you replace filters what is the amount of oil do you need thanks

have a craftsman t210 model 13b0a1zs093 with kohler engine ks540-3011 will not start battery good, tested solenoid tested good fuse good. any clues to where to go from here in order to get it running thanks

have a cub cadet ltx 1040 model 13rx90ar056 with kohler engine sv590-0220. the unit will not start or turn over, have replaced battery, solenoid, seat switch, pto switch, brake switch and installed new inginition switch module , fuse good still nothing any clues would be very helpful thanks

have the following kohler courage 20hp engine sv600-0024 that has a crack in the upper crankcase due to bolts coming loose to top end of engine, looking for any suggestions to make repairs, mower belongs to 80 year old lady so she does not want to replace the crankcase due to cost and her age...

b/s 40h777-0168-e1 will only start when starting fluid is used, once starts runs good, carb has been cleaned fuel pump is working any suggestions would be great thanks ac

placed this engine 40h777-0168-e1 in a old john deere had to install new key switch, solenoid, and rewire, engine has been starting up and running good then for some reason will not start now, checked for spark on both cylinder's none, disconnected the coil ground wire still no spark, any clues...

have a xt2 13wia4cn010 that will not start and clutch will not engage, replace ignition switch and pto switch no change, did a wiring check everything looked good, so i am at a total loss as where to go now would like any help thanks in advance AC

have a echo pb500h backpack blower it will start but not increase speed in order to increase wind speed could it be the carburetor any suggestions would be great thank you in advance

cub cadet model I1050 number 17af9bkp010, this mower turns to the left but will not turn to the right, the gears next to tires good, when you turn the steering wheel to the right will start turning then it free spins, am i looking at internal problems in the steering assembly, any comments or...

had this jd ztrak 25 hp 60 inch deck running,and stopping several times to test safety switches , stopped engine went to restart does nothing, the pto will engage could i have a start relay have gone bad. any cooments will be helpful thank you

i have a honda gc190 la on a cub cadet tiller rt65, have cleaned carburetor when starting the engine runs at full speed, this engine was worked on by someone self not sure what they did , so could i have a governor have been set wrong by the last person that worked on it and if so how do i fix...

i have a huskee lt4600 model 13w878st031 with a mtd engine 4x90hu compression is 75 psi. my problem is that when you go full throttle the engine speed does not change, the engine has one link connected to the governor that extends to the carburetor for throttle. replaced carburetor this did not...

have a b&s model 44u877-0005-g1 serial number 180123yg : owner said was running good then heard a pop stopped mowing parked, did a compression check found both cylinders were 60 psi, one plug had a little moisture on it other was dry. i believe that the compression should be over 90 psi is that...

have a cub cadetsc500 21 inch electric start mower with the following engine 2P70MU have cleaned carb it will start and run for a few seconds acting like not getting gas, so put a new carb on it and it does the same thiing, will not stay runnung like it is not getting gas any help would very...

have cub cadet xt2 model number 14a7a3ca010 year 2015, mowe runs good and pto engages correctly, but when try to set the rmc to go into reverse to mow it will do that as soon as you go into reverse the pto shuts off. have replaced the reverse switch, changed out ignition module and pto switch...

i have a cub cadet xt1 model number 13a8a1cs010 with the following engine mtd 547cc model 1tm1qcd449 / 4x90hu the mower starts up great but will surge at low throttle and when you increase throttle will still surge but when you engage blades the surging goes away and mower runs great, concerned...

i have a cub cadet 2015 xt1 model number 13apa1ct056 with a kohler engine, when key turned nothing happens. owner replaced the ignition switch, fuse is good. i have replaced the following safety switches: seat, brake, manual pto, and overridden the transmission switch, replaced the solenoid...

have a craftsman c410 cultivator have no model data available but the unit has a 4 cycle engine when you go to start it will run for a second or two with starting fluid when dies there is a gargling sound from the carburetor not sure what would cause and what the fix is thanks

i have a yta22v46 that has a general transmission and the problem is in the shifting into reverse and forward. the problem in order to get it to go into reverse you must stomp the reverse pedal and if you want to go forward after that you have to stomp the forward pedal have cleaned grass build...

i have a country line log splitter with a kohler sh265-3011 engine the engine will not increase rpm when the throttle position is in max speed postion. the compression is 35psi, replaced carb but unit still do not increase the rpm, the governor springs are correct according to service manual...

have a zg277z mower that i was told will start with jump and only runs for few seconds. first problem found was that the stater was not engaging, checked fuel pump for flow when key turned on no flow from fuel pump did a check of fuel pump with 12 volts applied no flow, then check to see if...

have a b/s model 44t977-0023-g1 on a john deere Z535m, using old school to check coil firing i placed my hand on valve cover one side got hot fast but the other did not heat up, so i suspected that coil was bad so replaced coil no change, checked valve clearance was off a little so adjusted did...

have a briggs aand stratton engine model 31g777-0290-e1, would not start all basic there new carb, electrical ok. pulled valve cover found that intake push end was broken at rocker arm, replaced. went to adjust valves set engine to tdc set at .005 turned engine by and to recheck clearance there...

have a cub cadet gt1554 model 14ak13bk709 with the following engine kohler courage 27 hp model sv740-0010. first problem was there was no spark so replaced spark advance module (coil) ran for a few days then no spark. so replaced coils mower will start and run but when you turn it off it will...

have a hasvqvarana rz4623 replaced the engine with kohler courage 23hp which was the same model on the mower from start, replaced the wiring harness since old was bad, replaced battery with 360 cca, replaced solenoid. when trying to start there is clip from solenoid. but can take jump box and...

i have the following lawn tractor sabre 14.5/38 gear gx1438a016531with b/b engine 287707-1274-e1when you turn the ignition key the fuse blows. looking for any help and if possible electrical drawing so i can trouble shoot better , in past have disconnected the stator and resolved problem this...

i have a kohler cv15s-41562 started out not running checked the mechanical fuel pump to ensure it worked had to prime in order to get it to work still would not start then cleaned carb had to spray either into carb before it would start but it did and ran good, let set for few days went to...

i have a push mower with a 5 hp b/s engine that will not start unless you use starter fluid. i have clean carb replaced primer bulb, air filter base plate, did not resolve the problem still needed starter fluid, so replaced carb, this did not reslove the problem still need starter fluid to get...

i have the following engine briggs and stratton model 33r877-0009-g1 it does not want to start cleaned carb still will not start. but will run run also long as starter fluid is put into carb, replaced carb with new one still would not start. after running engine with either there was one...

i have a lesco z-two mower trying to find parts for this mower here is the data that i have 25kwa/60 description 02001751 item number 7217511d136z80029 serial number looking for deck parts and any belts required thanks

i run my briggs engine for an hour and when i shut engine off the engine will diesel (try to run backwards). engine starts up fine runs great. camshaft was replaced 3 months ago. what could be cause and the fix thanks

have a hustler raptor that the owner had the ignition switch went bad, owner replaced but unit would not start. i found bad fuse, replaced tried to start blew fuse. have done a check of conductivity of wires found nothing, i know that i have ground just trying to find a real pain, i have...

i have a honda gcv 160 i can not get any spark replaced coil, spark plug and ground wire and still no spark any clues thanks AC

I have a poulan pro p54z (zero turn) that i replaced the motor starts great but when i take the brake off it dies. i have replaced all of the safety devices and pto switch and there is not change still dies when brake is taken off. looking for any help and electrical drawing for this mower to...

have a b/s 24 hp model 44s877-0040-g1 , compression 50 psi on one cylinder 60 psi on other one. replaced one coil have both cylinders firing. engine will start run for a little amount of time, but will start right back up, acts like it runs out of gas fuel pump good, solenoid bad but stays open...