Search results

It's still leaving strips. I'm not sure but I think part of the problem is the support plate that's bolted on the bottom front of the deck. I don't know what the real name of it is but it is bolted on the edge of the deck on the right and runs from mid blade to the discharge chute. At any rate...

Nope As I posted new mandrels new blade and new belt. I checked blade to blade alignment on all four ends and they are look very close. I also checked where they line up on the deck and end for end the match up all most perfect.

I've had this happen with both my old craftsman mowers. Once to the point the engine wouldn't turn over because the cylinder was full of fuel. I just changed the oil and put in a shut off valve in the fuel line. Now when I'm done mowing I shut the gas off and let it run till it dies and the turn...

I have two of these mowers and just bought a third for parts. One cuts great while the other started leaving a 4 to 6 inch strip where the grass is about an inch higher than the rest. The strip close to dead center on the right blade or just a little to the right of that. It was doing this at...