Recent content by KlinkSanford

Excellent, I thank you all for taking the time to respond to me. God Bless

Fixing a Hustler Fastrack 36" with a Kawi FH541 17hp for a friend, put in new carb and adjusted everything to run at 3600 WOT and a nice idle speed. Only problem is that when I turn off the engine, the governor does not go back all the way to the idle stop. So, when I go to start it again, I...

PROBLEM SOLVED! It runs again. I remembered a sort of similar problem on an outboard motor, when I went to start it, the starter would hesitate, turn slowly for one second then it would turn fast, run normal. It occurred to me that the boat ground cable was a smaller size than the positive...

Charged the battery to 12.90v. bypassed all four safety switches and tested voltage of safety system with key in the on position and had 12.87 volts, so voltage is flowing through safety system wiring. Connected multimeter to harness green wire that goes to the starter and got 12.86 volts when...

The starter on my Scag Wildcat 52 won't crank. Checked the safety switches, the relay, key switch, PTO switch, all checked out. Additionally, swapped a spare good key switch, no change. Swapped a good spare relay, no change. Removed starter and bench tested, works great. Tested green wire from...

I was looking online for information on greasing these aftermarket Oregon 82-325 Cast Iron Spindle replacement for Scag 46631 spindles, and I found a lot of conflicting information as to the construction and the corresponding greasing schedules for Oregon spindles. Most said all of Oregon's...

My Scag Wildcat parts manual shows the Push Arm as 461516. The parts manual for the SSZ mower above shows its Push Arm as 46460. I found that a Scag ad on Amazon for the Wildcat Push Arm 461516 also replaces the 46460 Push Arm that goes on the SSZ. So, I am just going to set my push arms at 15...

Below is a manual for a different mower, its push arm is different part#, but this manual shows the push arm adjustment, while the Wildcat owners manual does not. Anyone know what the push arm length adjustment should be for a 2007 Wildcat?

I replaced both ball joint rod ends on both the right and left Push arms and now the rear deck chains are angled somewhat forward, like the push arms are pushing the deck forward, is that OK, or should I screw in the rod ends further into the Push Arm till the deck chain is straight up and down...

I have a 2007 Scag Wildcat STWC52V-25KA, 52" with a Kawi 25hp which I bought from my neighbor about two months ago. The motor and the deck are newer like from 2014 and it sat like 2 years unused, so I bought it from him. I changed the engine and hydraulic oils & filters, changed the center...