Recent content by jono252525

Your right , I did not know that I had to balance the flywheel. I think that I will have to drop that idea and find another generator with the starter built in.

Well I did see a video that a ring gear can be fit on the flywheel but the guy is not giving the part number and for a clone starter cannot by that expensive and the battery is the same, for the rest ,I have it in my drawer.

I have a Coleman Powermate 5000W Year 2006 with Tecumseh model HM100 10hp generator with pull start I would like to install an electric start to this using a 12V battery Can you just get a conversion kit ? Or can you give me the parts numbers of the following. I need the ring gear for the...

I did that after rebuilding the engine but I will check them again. Thank you

Craftman Generator 6300 Watt with a Briggs Straton engine 11 HP , The model is 10T802 and the Type is 1130 B1 and the Code is 08031354 I rebuilt the engine 2 years ago and it run fine and it was use for 5 days in a row last year with no problem. But there is a small thing that it always did...

So conclusion , I found a spring that fit and the clone cab is working fine now

I made the hole bigger in the new carb pilot jet and right now, it is almost perfect. I am trying to make a spring that will fit over the trottle rod so it will eliminate a bit of the back lash.

Thank you for the info Star Tech.

Well your info a bought the original cab that are simple repair was not the case here since a local dealer did try before me to fix it and that did not work. So I was asking for help, not for what was not done! Thank you again.

Well, I guest that If I have to buy a OEM carb, then I will trash the unit because you can buy an other generator for $275. Perfect for the planet. Thank you.

I have a Coleman 5000 generator with a Tecumseh 10 HP engine model 159493X with carburation version 1003C serie: 06187CB1137 The carburator number: 5199 B6E 516 sub by 640260B. The problem is that the engine run but the RPM is very jumpy and it makes a back fire and it also revolution up...

Like I told you Star Tech, I would let you know how it went for honing my cylinder, It took me over 40 hrs to make it good with in .002 but I had to use home made tools + the standard one to make it. The engine now is running good.

Thank you for the informations.

I only need the tork spec for the generator Generac model 5500LX, Rotor bolt and Stator bolts.

Yes