Recent content by cambre

Yes I have one. Shows every thing but not how the hoses run from here to there. Thanks for answering.

Looking at the picture the left cylinder has 3 fittings, I have 2 hoses for 2 of them, at a loss to what goes on 3rd one. Thanks Mr. Purvis. I will make a drawing showing the fittings, I will have to get my neighbor to show me how to post it.

I have a very good complete repair manual. Thanks

cpurvis, thanks for drawing. That helps a lot. You get to help me again. Thanks

Does two hoses go from cylinder to cylinder? Thanks

yes I have

Thanks for replying slomo, I will try that.

I took the two swing cylinders off of my Kubota L35 backhoe about 4 months ago and did not take pictures (stupidity on my part). Can anyone post a drawing of how the 4 hose go back on? Many thanks to anyone who helps me on this.

The Model #107.287910, discontinued long ago. So the kill wire from ignition switch goes to the magnetos, this is all I needed all along. Thank you very much.

This eng. is 12yrs old, I have done a lot of things to it in all these yrs. Any normal person would have thrown it away long ago but I ain't normal don't you see.

The key switch is not the problem, its where the kill wire that comes off the key switch go to.

I know where the kill terminal is on the switch, need to know where wire goes on the engine.

It is a Kohler 26hp twin, model #107.287910 serial #3805700373, SV 710-740,spect #SV735-0018. No S.A.M

What is the white wire (witch it does not have) coming out of the engine attached to what?

Had to replace the wiring because of fire so all the wires are yellow & red. I used what I had. The kill wire from the kill connection on ignition switch has to connect some where to kill the engine. Some one should know this.